Excellent quality Lightning Surge Protection Device - Surge Protector Device 18OBO Structure – Leihao

TN-C-S system

Surge in power supply system mainly comes from two reasons: external (lightning) and internal (start-up, stop and failure of electrical equipment, etc.). Surge is often characterized by short time (overvoltage caused by lightning is often in microsecond level and overvoltage caused by electrical equipment is often in millisecond level), but instantaneous voltage and current are extremely large, which is likely to cause harm to electrical equipment and cables, so surge protectors are needed to protect them. Surge ProtecTIve Device (SPD) is an electronic device that provides safety protection for various electronic equipment, instruments and communication lines, and is mainly used to limit overvoltage and discharge surge current. Surge protectors are generally connected in parallel with protected equipment, which can shunt and limit voltage when overvoltage occurs. Prevent excessive current and voltage from damaging equipment.

Structure and principle

LHSPD is a port ,shocking protection, indoor –mounted installation, voltage-limited.
LHSPD  hold disconnector inside, then LHSPD breakdown failure by over heating,the disconnector  can  remove from the power  grid  automatically, and show  indication  signal, when  LHSPD is  working  properly, visible window  display green , lt display red when it breakdown and disconnect. 1P+N ,2P+N ,3P+N  spd consist  of 1P ,2P ,3P  SPD + NPE  zero protection  module , apply to TN-S、 TN-C-S and other power supply system

Product installation

With 35mm standard DIN-rail mounting, connecting copper stranded conductor is 2.5~35 mm².

At front of LHSPD each pole must be setted protection —used fuse or miniature circuit breaker lightning current LHSPD protection ,after LHSPD breakdown to short circuit protection.

LHSPD install on protected line (equipment) to the front and connected to supply line. A class products install in the building home-entry line hold large surge current total distribution box.B,C class products most install on the floor distribution box ,D class products close to the front – end equipment that smaller surge current, smaller residual voltage place

The company consistently adheres to technical innovation, continuously improves the product grade, takes the creation of world tool brand and the quality policy of customer satisfaction products at home and abroad; We listen to customers’ voice and provide solutions to problems; Respond to customers quickly, ensure that every customer is satisfied and promise to provide high-quality service for customers.